There are several methods you can use to do this:. If your lampshade has light dirt marks or staining but is not robust enough to immerse in water, first remove any non-washable trim. Mix a bowl of cool water with some delicate fabric detergent and apply just the soap suds to the shade in sections using a microfibre cloth, turning the shade each time to ensure full coverage.
Then gently rinse off the suds and wipe the lampshade dry. Note that spot-cleaning a fabric lampshade can sometimes cause a water mark or dye stains or a particularly noticeable clean spot!
So cleaning the whole shade will help to ensure an even finish. For more stubborn dirt, or if your fabric lampshade is heavily stained, for example with grubby hand prints or water marks, you made need to take tougher action. Put on some rubber gloves and fill a large, clean container or a bathtub with lukewarm water cool water for glued fabric lampshades.
The water should be deep enough to fully submerge your lampshade. Add in some delicate fabric cleaner and stir, to create suds. Now gently immerse the lampshade, holding it securely by the frame. Using a sponge or cloth, gently wipe the lampshade using an up and down movement. For very difficult stains, you may need to soak the lampshade for a few minutes. Change the water as often as needed, until it eventually runs clear.
Once the shade is clean, empty your tub a final time, refill it with clean water, and dip the lampshade in and out of the water to remove any excess soap. Fabric lampshades can sometimes appear to stretch when they are washed.
However, they will return to their original shape when fully dry. The key is to make sure that they dry out evenly. Gently shake the lampshade and pat it with a soft, clean towel to remove any excess moisture, then either hang it over the bath or stand it in a well-ventilated spot to air dry.
If the weather is warm enough, you could dry your lampshade outside. You can also use a hairdryer or a fan to help dry out your shade, but again care is needed. Use a cool setting and set the device inches aware from the lampshade.
Once your lampshade is fully dry, you can reassemble everything. If your lampshade has pleats or ruffles, check that they are in good shape and put any removable trims or ornaments back on the lampshade. Then put the shade back on the base and pop the bulb in, screw it all back together, plug in and… let there be light! Blot the shade with a towel to remove the water. Place it outdoors or in front of a fan to speed up the drying process.
Becker is a certified yoga teacher based in Queens, N. She has a Master of Fine Arts in creative writing and has worked as a writer and editor for more than 15 years. Becker Updated December 29, Related Articles.
Rinse and wring out the sponge or rag. Wipe the suds from the lampshade. Things You Will Need Microfiber cloth, lint roller or vacuum cleaner Liquid laundry detergent, dishwashing liquid or baby shampoo Sponge or rag Soft toothbrush or nylon-bristle scrub brush Delicate laundry detergent. Tip For silk, embroidered or heavily beaded or sequined shades, consult a professional cleaner.
See photos if I can figure out how to upload them. But you could probably lightly sponge clean them. I have a swag lamp with what appears to be a bone shade.
This is 20 years old and looking quite brownish How do I clean this? It looks quite grungy. I try to clean a silk lamp shade that is made with a strong material like plastic I am not sure if it is plastic, but is hard attached to the silk. I used a small piece of cotton with a little soap because looks like the spot was grease. Although the grease is gone, when the silk lamp shade was dried, there were some parts of the lamp that has marks along the area that was cleaned.
How can I take this marks out? Thanks you. You might try contacting a local dry cleaner to ask for their advice. I hope you find a solution!
0コメント